100mm 4" verticle 90° ducting elbow joint selfseal push fit

Downloadable Ducting Chart
PDF File - Opens in a New Window

Airtight Self-Seal Ducting

Please note most of our hoods have a motor outlet of 150mm. You will require a reducer collar to use System100 ducting.

We highly recommend using the largest possible size ducting on every installation to maximise air flow.

Please check each product specification guide to determine what size duct you require.

100mm x 60mm 90° Vertical Elbow

This part is used for connecting two 100mm x 60mm flat ducting pipes to each other at a 90° vertical bend ensuring smooth airflow is achieved through corners.

Low-profile dimensions of the duct and fittings allows it to be easily concealed where space is restricted. It offers high airflow performance, making this system perfect for both whole house systems and single extract requirements such as Bathroom, Kitchen, and Utility Room extract systems.

This patented push fit system requires no ugly ducting tape and ensures a airtight seal between coupling.

This is part number 7 from the ducting chart below

This clip is part of our System100 range, commonly referred to as 4 inch ducting due to the round pipe being 100mm / 4" wide. This system includes both 100mm x 60mm rectangular ducting and 100mm round ducting as they both have similar airflow rates. We supply adapters should you need to switch between these sizes:

Round to Flat Adapter

Round to Flat Elbow